LabPac® OmegaMeter 600 Resistivity Sensor

  • Model: 0301171
  • 0 Units in Stock
  • Manufactured by: scientific solutions

$2,295.00

 Sold Out 
Description

In the OmegaMeter, the resistivity is measured by use of a sensor that comes in contact with the test solution and by circuits that take the sensor's measurement and convert it to a reading on the LCD screen.

Here are the steps to replace a sensor

Make sure the test cell is drained of fluid
Unplug the OmegaMeter from AC power
Unplug the Resistivity sensor electrical connection
You will have to unscrew the connector housing
Then separate the connector
Carefully remove the Resistiviy Sensor from the plumbing
The Resistiviy Sensor is threaded and you will need a wrench to unscrew the sensor from the plumbing
Remove the old Resistivity Sensor
We recommend you use some plumbing Teflon tape around the threads of the replacement Resistivity Sensor
Carefully screw in the new sensor making sure it is snug so as not to leak around the threads
Plug in the Resistivity Sensor electrical connection
Test for leaks

Once the new sensor is in place and you are sure you have no leaks, then you should perform a Chemical Verification using the Scientific Solutions #3 Standardizing Solution to verify correct operation.

This product was added to our catalog on Saturday 07 September, 2019.

Copyright © 2020 LabPac. Endorsed by Scientific-Solution.com